When the FC is powered on and in standby mode, the BOOT button can be used to controller the LED strips connected to LED1-LED4 connectors on the bottom side. Press and hold BOOT button and power the FC on at the same time will force the FC to enter DFU mode, this is for firmware flashing when the FC gets bricked. Used for WS2812 LED controlled by Betaflight firmware. M1 - M4 on bottom side and M5-M8 on front side.ĥ sets(UART1, UART2, UART3, UART4(For ESC Telemetry), UART6) Designed for receiver and GPS module even when the FC is powered through the USB port. The total current load is 2A.Ģ groups of 9V output, one +9V pad on front side and other included in a connector on bottom side. Completely compatible with DJI O3/RunCam Link/Caddx Vista/DJI Air Unit V1, no wire is needed to be changed.ġ0 groups of 5V output, three +5V pads and 1 BZ+ pad( used for Buzzer) on front side, and 6 +5V output included in the connectors on bottom side. Two ways supported: 6-pin connector or direct soldering. Supported.Please enter MENU > Blackbox Analyzer

Led pinout download free